You can run Oracle Net Configuration Assistant (NETCA) in silent mode to configure and start an Oracle Net listener on the system, configure naming methods, and configure Oracle Net service names.

1. Copy the netca.rsp response file template from the response file directory to a directory on your system.
   copy \directory_path\assistants\netca\netca.rsp local_directory
   In this example, directory_path is the path of the directory where you have copied the installation binaries.
   If the software is staged on a hard drive, or has already been installed, then you can edit the file in the response directory located on the local disk instead.
2. Open the response file in a text editor.
3. Follow the instructions in the file to edit it.

   Note:

   NETCA fails if you do not correctly configure the response file.
4. Log in as an Administrator user and set the %ORACLE_HOME% environment variable to specify the correct Oracle home directory.
5. Enter a command similar to the following to run NETCA in silent mode:

   C:\> Oracle_home\bin\netca -silent -responsefile X:\local_dir\netca.rsp

   In this command:

   • The -silent option runs NETCA in silent mode.

   • X:\local_dir is the full path of the directory where you copied the netca.rsp response file template, where X represents the drive on which the file is located, and local_dir the path on that drive.